This website requires a minimum of Internet Explorer v9. Please upgrade your browser or use Chrome or Firefox.
 Crown CDi 2|300 available for rent in Toronto with Quest Audio Visual

Crown CDi 2|300

The CDi DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost.  Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2|300 offers streamlined functionality to work in almost any small/medium sized installation such as restaurants, retail stores, and more.  Designed for ease-of-use in a variety of applications, the 2|300 is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer.  The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier.


  • DriveCore Technology – Crown’s proprietary DriveCore technology eliminates hundreds of components within each amplifier, reducing the variability of component values, increasing reliability, resulting in incredible audio fidelity from an efficient design.
  • Network Control and Monitoring – Through Harman’s HiQnet Audio Architect software, the CDi DriveCore can be controlled, configured, and monitored through standard TCP/IQ network.
  • DSP – On-board Digital Signal Processor in each amplifier allows for custom configuration • Input Router • Input Delay – Up to 1000ms • Input Parametric EQ – 8 band • Crossover • Output Parametric EQ – 8 band • Output Delay – Up to 100ms • LevelMAX™ Limiter
  • BLU link (BL models only) – Both receive and send channels over HARMAN’s 256 channel, fault-tolerant audio BUS, BLU link
  • Direct Drive 70/100Vrms Output – Each output channel is capable of provide either 70V or 100V for high impedance applications.
  • Front-Panel Interface – Completely configure the amplifier using an intuitive front-panel interface.
  • GPIO/AUX Port – Recall presets, mute channels, monitor faults, power on/off the amplifier, and more through a combined GPIO/AUX Port.


  • BLU link : No
  • Channels : 2
  • Sensitivity (for full rated power at 8 ohms) : 0.7v RMS
  • Rated Power Output (per channel @ 4 ohms) : 300W
  • Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz - 20kHz) at 8 ohms) : >104dB
  • THD (full rated power, 20 Hz - 20 kHz) : 0.35%
  • Damping Factor (20 Hz to 100 Hz) : >1000
  • Frequency Response (8Ω, 20 Hz - 20 kHz) : +/- 0.5dB
  • Crosstalk (below rated power) 20Hz to1kHz : >80dB
  • Input Impedance (nominally balanced, nominally unbalanced) : 20 kΩ balanced, 10 kΩ unbalanced
  • Dimensions (inches)(W x H x D) (depth not including 1.3 inch front panel protrusion) : 19 x 3.5 x 12.25
  • Weight : 14.56 lbs (6.6kg)
  • Power Supply Connector : Standard IEC type 320 inlet for detachable connector 100-240V~